Eight elements of solid wood floor installation in

2022-07-22
  • Detail

Eight elements of solid wood floor installation in Xi'an decoration classroom. First, clean the ground before installation and construction to ensure that the ground is flat and clean. II. The earthworm bone must be made of dry wood with a moisture content of less than 17%. The ground keel must be planed uniformly after construction, and the keel height must be unified with a horizontal line, otherwise free cracks between the floors will be produced due to pressure in the future. III. If the ground environment is wet, moisture-proof treatment should be carried out, and a layer of moisture-proof protective paint should be painted on the back of the floor

eight elements of solid wood floor installation in Xi'an decoration classroom

first, clean the ground before installation and construction to ensure that the ground is flat and clean

II. The earthworm bone must be made of dry wood with a moisture content of less than 17%. The ground keel must be planed uniformly after construction, and the keel height must be unified with a horizontal line, otherwise free cracks between floors will occur due to pressure in the future

III. If the ground environment is wet, moisture-proof treatment should be carried out. At the same time, a layer of moisture-proof protective paint should be painted on the back of the floor, especially on the back and side of the floor connected with the kitchen and bathroom. The ground of new residential buildings should be painted with moisture-proof paint for moisture-proof isolation treatment

IV. do not fix the ground keel with cement to prevent the floor from moisture and deformation. If it has been sealed with cement, the ground keel can be sealed and painted with paint

v. during construction, about 1 cm of space must be reserved for the floor horizontally against the wall to take advantage of the floor expansion caused by climate change

VI. the interface between the floor and the floor cannot be glued, but must be nailed to the keel with floor nails 45 degrees from the opening

VII. After the floor is assembled, it must be painted with sealing primer immediately on the same day for protection. If it is left aside for too long, the unpainted floor is prone to damp or dry, and it is difficult to clean up once it is polluted

VIII. Strong sunlight is not allowed near windows and balconies to avoid changes in the floor due to exposure

武汉皮肤病医院

杭州男科医院

太原男科医院

Copyright © 2011 JIN SHI